Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bootfile not in stand by

Hello !!

I have this message in my 7606 router's log:

The bootfile slavec7600s72033-advipservicesk9-mz.122-33.SRB2.bin is not present in standby.

What does it mean ?

How can i fix it ?

Thanks

7 REPLIES
Hall of Fame Super Bronze

Re: Bootfile not in stand by

You need to copy the IOS image in the standy Supervisor as well.

HTH,

__

Edison.

Re: Bootfile not in stand by

But the router was operating normally(since 2 months ago), it was not turned off, the IOS has not been changed, nor the register....what can produce such event log ?

Hall of Fame Super Bronze

Re: Bootfile not in stand by

Perhaps someone deleted the file by accident.

Verify the file is there, if it isn't - please copy it from the active Supervisor to the standby.

HTH,

__

Edison.

Re: Bootfile not in stand by

Hello Edison. Thanks for your responses.

Could you please give me a procedure to follow (including commands) so i can verify if the file exists or not and if not, how to copy ?

I'm just a begginer in my job and my boss asked me to perform this taks (to find out how to do that).

Thanks a lot

Hall of Fame Super Bronze

Re: Bootfile not in stand by

Please take a moment and read the portion of this document:

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_example09186a0080116ff0.shtml#maintask2

It explains several commands regarding the task you are asked to do.

HTH,

__

Edison.

Re: Bootfile not in stand by

Eduard. Hi again.

This is the equipment's sh ver print:

System image file is "bootdisk:c7600s72033-advipservicesk9-mz.122-33.SRB2.bin"

cisco CISCO7606 (R7000) processor (revision 1.0) with 458720K/65536K bytes of me mory.

Processor board ID FOX084000FG

SR71000 CPU at 600Mhz, Implementation 0x504, Rev 1.2, 512KB L2 Cache

Last reset from s/w reset

23 Virtual Ethernet interfaces

52 Gigabit Ethernet interfaces

1917K bytes of non-volatile configuration memory.

8192K bytes of packet buffer memory.

65536K bytes of Flash internal SIMM (Sector size 512K).

Configuration register is 0x2102

I don't really understand how can i copy files from one memory to other.

How can i know how many slots for memory my router has ?

Hall of Fame Super Bronze

Re: Bootfile not in stand by

My name is Edison.

Please post the output from typing dir /all

__

Edison.

165
Views
0
Helpful
7
Replies