Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

booting problem in l3 catalyst 4006 switch

I m facing problem in booting the catalyst 4006 switch

1) it has supervisor III engine.

the symptoms are- it is showing blinking red on Status LED

2) It is not giving any output when i m connecting it by console.

1 REPLY
Purple

Re: booting problem in l3 catalyst 4006 switch

Not much to go on , if you are getting no output from the console and you are sure your emulator settings and cable are correct then its time to get the supervisor replaced.

138
Views
0
Helpful
1
Replies