Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Boradcast & Storm Control on Siwtches

Hi All, I have L2 vlan in my network for internet guest users which is totally separated with our corporate network by L2 vlans but they are sharing our access switches, now I am concerned about worms & virus in guest internet L2 network, if any kind of viruses casues broadcast or storm in network that can destroy our switches as we are sharing switches with guest & corporate users. Is there any way to control broadcast & storm in a vlan. Port based I know. I want to do for a vlan.

any one has any idea.

Thanks

3 REPLIES
Hall of Fame Super Bronze

Re: Boradcast & Storm Control on Siwtches

Are you thinking about placing the configuration changes in the SVI ?

Well, broadcast does not leave a Vlan, so placing any control at the SVI (Layer3 interface) brings no benefit.

New Member

Re: Boradcast & Storm Control on Siwtches

Hi Jain,

You can use a feature called "storm-control broadcast level XY%" and configure it on fastethernet or giga ethernet interfaces. XY is a value in percentage, and this will drop down all broadcasts, that are above this level for a period of time and so protects your switch.

Reffer to:

http://www.cisco.com/en/US/docs/routers/7600/ios/12.1E/configuration/guide/storm.html

Be careful when configuring both broadcast+multicast, unicast or any combination.

Crossing over of configured level of anyone (broadcast, multicast, unicast) will stop all of them.

So if you want only multicast to be limited, do not configure multicast or unicast.

HTH

Regards

Ivan

[pls rate any helpful posts]

New Member

Boradcast & Storm Control on Siwtches

hi,

To prevent virus to spread throughout the network ports or switches, can i used broadcast storm to control?

sometime, network may encountered loop, or some virus spread, so by apply below will help?

interface gi0/1-24
storm-control broadcast level ?
storm-control multicast level ?
storm-control unicast level ?
storm-control action shutdown

I need some advise on the level, what will be recommended level? or the threshold / pps ?

I read through cisco website, and understand, however, just never apply before, what is the recommended level for ?

in my network, we do have network ports connected to media server, just sharing video, song, etc for testing purpose, however not using PIM, but it work.

Is it recommended using PIM ?


221
Views
0
Helpful
3
Replies