I have a Cisco 4948 Catalyst. We have been asked to configure BPDU globally. So I believe the command is Switch (config)# spanning-tree portfast bpduguard default. After entering the the global command is it possible to disable the command on an interface level? That would save me from having to enable it on each interface. We may have a linksys switch to connect to the 4948 and at this moment I'm not sure what port it will be. Thanks for your help!
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.