Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

BPDUGUARD on an interface level

Hi,

I would like to enable bpduguard on all our trunk ports configured for voice and data traffic on our 3750 switches. I would like to block so no one can plug a switch or a hub.

Thx

1 REPLY

Re: BPDUGUARD on an interface level

Hi Friend,

yes, you can configure the spanning-tree bpdugurad on the trunk interfaces. To configure this feature on per interfaces use the following command.

config t

Switch(config)# interface gigabitethernet2/0/1

Switch(config-if)# spanning-tree bpduguard enable

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12225sed/cr/cli3.htm#wp1945530

HTH, Please rate if it does.

-amit singh

152
Views
0
Helpful
1
Replies
CreatePlease to create content