Bridge Protocol Options

[j-griffin]

I am replacing some 4908G L3 switches with some 3750G L3 switches and am having a problem with the bridge protocol command. On the 4908s I have the following commands…

bridge 1 protocol ieee

bridge 1 route ip

bridge 1 priority 100

However on the 3750G L3 switch with 12.2.25 SEB4 Enhanced Multilayer Image software

I don't have an option for “bridge 1 protocol ieee”, I only have the option for protocols dec,ibm or vlan-bridge.

How can I configure the bridge protocol to support ieee?

[didyap]

IOS running on the 3750G L3 switch with 12.2.25 SEB4 Enhanced Multilayer Image software does not support the IEEE bridging protocol for bridge groups, Meaning ieee is not supported for bridge groups running IOS. You should configure bridge groups to use VLAN-bridge or DEC protocol spanning tree.