I have a multi site WAN,MPLS primary and secondary circuits, 6 sites. One site is the data center. The DC is moving so we have a bridge (2 3800's) connecting the server VLAN (10.2.5.x) while we migrate servers between sites and want to keep both data centers up.
The configs look correct. Every site can successfully run the apps over the bridge except the old data center (other side of the bridge). VPN users and users for the other 5 sites work fine. Users in the new data center can run everything successfully as well. Just the users in the old data center cannot.
Traceroutes look OK. I will post configs after some extensive editing ( proprietary info). Just hoping that someone has seen something similar. Thanks...
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...