Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

bridging serial link to ethernet

Hi all, If I have a leased line connection presented on a 2 meg serial connection on my router, would it be possible to bridge between them, would I have to configure the router as a bridge either end, is this possible ?

cheers

Carl

2 REPLIES
Community Member

Re: bridging serial link to ethernet

can anyone help on this ?

Silver

Re: bridging serial link to ethernet

You can set up your router as a bridge. enable no ip routing on your router. The serial link set for bridge group 1 and add the same command to the ethernet interface. Add bridge group 1 protocol ieee (global command). This will enable the router to be a bridge and will bridge the traffic from the ethernet to the serial link....Good Luck...

273
Views
0
Helpful
2
Replies
CreatePlease to create content