hi all, i have a 2821 router with 4ESW HWIC installed. we have some vendors sitting in our dept so we seperated there switch and connected an uplink on HWIC's port and created a seperate vlan 4 and assigend that port to vlan 4. given ip in interface vlan 4 everything was fine. they have one user who is having problem in connecting to one of our subnets server. Our subnet is 10.110.1.0/24 and their subnet is 172.16.1.0/24. at first i thought ip helper command will be sufficient but it didnt work at all. consider my server to be 10.110.1.12/24 and the vendors have confirmed that they use broadcast to connect to our server ( they used some complex terms which i dont know anyway :-) ). Now do i have to define the specific UDP port through forwarding address command or anything else i need to do ?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...