Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bug in 15.0(1)SE2 for 3560/3750 - IPv6 Loopback Interface?

I have two 3560 switches - a 3560G-24 and a 3560-48.  I am running the latest IOS release on each switch - 15.0(1)SE2 on the 3560G and 12.2(55)SE5 on the 3560.  I am running the same SDM template on each (desktop IPv4 and IPv6 default) and have IPv6 running.  The two switches share a common VLAN to a WAN router with a /64 IPv6 network, OSPFv3 is running on this and I have route visibility and full connectivity.  The WAN router and the two switches each have a loopback interface that has a /128 IPv6 address with OSPFv3 enabled.  The routing table contains these /128 networks.  I cannot access the interface on the 3560G but have no issues with the 3560.  The only difference I can see is the IOS version.

!3560G

interface Loopback0

ipv6 address xxxx:xxxx:xxxx:FFFF::2/128

ipv6 enable

ipv6 ospf 1 area 0

!3560

interface Loopback0

ipv6 address xxxx:xxxx:xxxx:FFFF::3/128

ipv6 enable

ipv6 ospf 1 area 0

!WAN Router

interface Loopback0

ipv6 address xxxx:xxxx:xxxx:FFFF::1/128

ipv6 enable

ipv6 ospf 1 area 0

Of the debugging I have done it appears the packets are hitting the 3560G but it isn't 'seeing' them.

I think this is a bug but can't seem to find any more information regarding it?

Andy

Everyone's tags (1)
1 REPLY

Bug in 15.0(1)SE2 for 3560/3750 - IPv6 Loopback Interface?

Although not in the release notes this has been fixed in 15.0(2)SE.

Andy

574
Views
0
Helpful
1
Replies
CreatePlease login to create content