Building Small Network with Interconnected 2960Xs - No Connectivity
I am trying to create a network with a client connected to a 2960X, which connects to a second 2960X switch, which connects to a server. I have setup the switch connected to the client with an IP address of 10.0.1.1 for its vlan1. The second switch has an IP address of 10.0.2.1 set for its vlan1. I then interconnected the two switches using the GigabitEthernet1/0/1 interface in trunking mode on each switch. I was not able to ping the second switch, so I then configured the GigabitEthernet1/0/2 interface in access mode and connected the two switches. I am still not able to ping the second switch from either side.
What do I need to do to get this setup working? Should I be using a single VLAN that spans the two switches? Should I be using trunking or access mode for the interface that interconnects the two switches?
That is correct, each switch has only one vlan, vlan1.
Subnet mask is 255.255.255.0.
Thanks, will change all interswitch connections to trunk. Will leave all host to switch connections at access.
Unfortunately, I cannot post the output as it is from a terminal that cannot be connected to the Internet or even the Intranet and USB storage is not permitted in the area, so I cannot copy the output into a text file on a USB drive. I would have to type everything out. If there are parts of the sections of these commands that may be show the issue, please let me know and I can type up those sections.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.