03-04-2008 07:22 AM - edited 03-05-2019 09:32 PM
I remember in catOS you could make changes to multiple ports with a single command. for e.g.
set vlan 99 2/1-6 etc.
So using the above as an example how would i do this in IOS?
Thanks a bunch.
Solved! Go to Solution.
03-04-2008 07:35 AM
interface range gigabitethernet 1/1 - 48
The spaces between the dash and numbers is necessary.
HTH
If so, pelase rate this post.
Victor
03-04-2008 07:35 AM
interface range gigabitethernet 1/1 - 48
The spaces between the dash and numbers is necessary.
HTH
If so, pelase rate this post.
Victor
03-04-2008 08:18 AM
Also:
-create a macro
Define interface-range int_range g1/1 - 48
-use the macro you created
Interface range macro int_range
Int_range represents a word describing the macro you created. The macro is saved in the run/start config.
03-04-2008 08:28 AM
Thaks guys. I am assuming the macro is set per switch, would that be correct?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: