Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Bulk Changes in IOS

I remember in catOS you could make changes to multiple ports with a single command. for e.g.

set vlan 99 2/1-6 etc.

So using the above as an example how would i do this in IOS?

Thanks a bunch.

1 ACCEPTED SOLUTION

Accepted Solutions
Blue

Re: Bulk Changes in IOS

interface range gigabitethernet 1/1 - 48

The spaces between the dash and numbers is necessary.

HTH

If so, pelase rate this post.

Victor

3 REPLIES
Blue

Re: Bulk Changes in IOS

interface range gigabitethernet 1/1 - 48

The spaces between the dash and numbers is necessary.

HTH

If so, pelase rate this post.

Victor

New Member

Re: Bulk Changes in IOS

Also:

-create a macro

Define interface-range int_range g1/1 - 48

-use the macro you created

Interface range macro int_range

Int_range represents a word describing the macro you created. The macro is saved in the run/start config.

New Member

Re: Bulk Changes in IOS

Thaks guys. I am assuming the macro is set per switch, would that be correct?

202
Views
0
Helpful
3
Replies