Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Bus Asic #1 transient Pb error

Error was seen from CISCO6506.

%PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 2 is experiencing the following error: Bus Asic #1 transient Pb error. Recovered. (0x0002, 0x0000)

Module 2 is WS-X6148-GE-TX

But all ports and protocols are running well all the time. Should I ignore this error?

1 REPLY

Re: Bus Asic #1 transient Pb error

no, it's not just an informational syslog. according to cisco.com's error message decoder tool:

%PM_SCP-2-LCP_FW_ERR_INFORM:

Module [dec] is experiencing the following error: [chars]

An error condition was detected by the line card firmware and the supervisor is being informed about it.

Recommended Action: Copy the message exactly as it appears on the console or in the system log. Research and attempt to resolve the issue using the tools and utilities provided at

http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying information. Also perform a search of the Bug Toolkit

http://www.cisco.com/pcgi-bin/Support/Bugtool/home.pl. If you still require assistance, open a case with the Technical Assistance Center via the Internet

http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support representative and provide the representative with the gathered information.

Related documents- No specific documents apply to this error message.

in other words, try to open a cisco tac case to further troubleshoot.

1197
Views
0
Helpful
1
Replies