Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

BVI interface not pingable on AIR-SAP1606I-E-K9

Hi,

 

I have seen discussions about this already but still cant get to the bottom of it.

These WAPs are fine when they only have a single SSID and VLAN on them and the BVI interface is in the data VLAN.

Now I'm trying to configure one with multiple SSIDs and VLANs.

Everything is fine until I reboot the WAP and then I cant ping the BVI interface from any other device on the network. The WAP still works: I can join the SSIDs and connect to relevant parts of the network.

 

The switch port connected to the WAP is a trunk with VLAN 1 as native. VLANs 20 and 25 are allowed on the trunk.

 

The SW version is:

Cisco IOS Software, C1600 Software (AP1G2-K9W7-M), Version 15.2(2)JB2, RELEASE SOFTWARE (fc1)

 

AP config:

!
! Last configuration change at 03:27:54 UTC Mon Mar 1 1993
version 15.2
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
!
hostname ap
!
!
logging rate-limit console 9
enable secret 5 $1$RnA2$uB5tTab9.e4zHaUhGt0c91
!
no aaa new-model
ip cef
!
!
!
dot11 syslog
!
dot11 ssid DATA
   vlan 20
   authentication open
   authentication key-management wpa
   mbssid guest-mode
   wpa-psk ascii 7 044B0A151C36435C0D
!
dot11 ssid GUEST
   vlan 25
   authentication open
   authentication key-management wpa version 2
   mbssid guest-mode
   wpa-psk ascii 7 111918160405041E00
!
!
crypto pki token default removal timeout 0
!
!
username Cisco password 7 1531021F0725
!
!
ip ssh version 1
bridge irb
!
!
!
interface Dot11Radio0
 no ip address
 !
 encryption vlan 20 mode ciphers aes-ccm
 !
 encryption vlan 25 mode ciphers aes-ccm
 !
 ssid DATA
 !
 ssid GUEST
 !
 antenna gain 0
 stbc
 beamform ofdm
 mbssid
 station-role root
!
interface Dot11Radio0.1
 encapsulation dot1Q 1 native
 bridge-group 1
 bridge-group 1 subscriber-loop-control
 bridge-group 1 spanning-disabled
 bridge-group 1 block-unknown-source
 no bridge-group 1 source-learning
 no bridge-group 1 unicast-flooding
!
interface Dot11Radio0.20
 encapsulation dot1Q 20
 bridge-group 20
 bridge-group 20 subscriber-loop-control
 bridge-group 20 block-unknown-source
 no bridge-group 20 source-learning
 no bridge-group 20 unicast-flooding
!
interface Dot11Radio0.25
 encapsulation dot1Q 25
 bridge-group 25
 bridge-group 25 subscriber-loop-control
 bridge-group 25 spanning-disabled
 bridge-group 25 block-unknown-source
 no bridge-group 25 source-learning
 no bridge-group 25 unicast-flooding
!
interface Dot11Radio1
 no ip address
 shutdown
 !
 encryption mode ciphers aes-ccm
 !
 ssid DATA
 !
 antenna gain 0
 no dfs band block
 stbc
 beamform ofdm
 channel dfs
 station-role root
 bridge-group 1
 bridge-group 1 subscriber-loop-control
 bridge-group 1 spanning-disabled
 bridge-group 1 block-unknown-source
 no bridge-group 1 source-learning
 no bridge-group 1 unicast-flooding
!
interface GigabitEthernet0
 no ip address
 duplex auto
 speed auto
!
interface GigabitEthernet0.1
 encapsulation dot1Q 1 native
 bridge-group 1
 bridge-group 1 spanning-disabled
 no bridge-group 1 source-learning
!
interface GigabitEthernet0.20
 encapsulation dot1Q 20
 bridge-group 20
 bridge-group 20 spanning-disabled
 no bridge-group 20 source-learning
!
interface GigabitEthernet0.25
 encapsulation dot1Q 25
 bridge-group 25
 bridge-group 25 spanning-disabled
 no bridge-group 25 source-learning
!
interface BVI1
 no ip address
!
interface BVI20
 ip address 192.168.152.252 255.255.255.0
!
ip default-gateway 192.168.152.254
ip forward-protocol nd
ip http server
no ip http secure-server
ip http help-path http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag
!
bridge 1 route ip
bridge 20 route ip
bridge 25 route ip
!
!
!
line con 0
line vty 0 4
 login local
 transport input all
!
end

 

 

Thanks in advance for you help.

 

 

Everyone's tags (5)
54
Views
0
Helpful
0
Replies