As I posted - you treat it like any other interface? Once the Layer-2 VLAN exists you just add the SVI with the command 'interface Vlan X' where 'X' is the VLAN number, by default it will be shutdown but a 'no shut' will bring it up. To put access ports in the vlan just make sure they are configured as access ports (switchport mode access) and they are in the right vlan (switchport access vlan X).
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...