Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

BW restriction/control on switch port(access port)

Hi,

Core sw(vlan10) == Etherchannel== Access(Vlan10)Gi0/1 === Server (vlan 10).

Access sw = 2960

I need to restrict the BW on switch port where my server connected(gi0/1). I have to restrict my port utilization to 80% as my server pumping huge data on port Gi0/1 and it should not exceed to more than that.

ex: if it is fe port, Traffic/data flow should not cross the 80mb

Is there any option like rate limit on switch port

Regards

sateesh

3 REPLIES

Re: BW restriction/control on switch port(access port)

just do policing

for example

policy-map map1

class classdefault

police [amount in bit] confirm-action trasmit exceesd-action drop

then apply it to ur interface

intg0/0

service-policy map1 input

good luck

if helps rate

New Member

Re: BW restriction/control on switch port(access port)

Hi,

I appreciate your prompt response..I will try and let know the details.

It seems to be how we apply on L3 interfaces like that only.I thought its something different on L2 network.

Regards

sateesh

New Member

Re: BW restriction/control on switch port(access port)

Hi,

I hope As per the below config once it crosses the SET BW LIMIT packets are gets dropped. But I need it should not gets dropped it should be qued once its crossed the SET BW.

I hope once its gets dropped is packet resend again or it will dropped?

police [amount in bit] confirm-action trasmit exceesd-action drop

Regards

sateesh

134
Views
0
Helpful
3
Replies