Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

by power-on .VS. by power cycle (SP by power-on)

Hello guys,

Do you know the difference between "by power cycle (SP by power-on)" and just "by power-on"? ... if there is any...

*

Time since mainsw1 switched to active is 9 hours, 5 minutes

System returned to ROM by power cycle (SP by power-on)

System restarted at 11:39:03 CDT Mon Sep 15 2008

System image file is "disk0:s222-ipservicesk9-mz.122-18.SXF7.bin"

note: Cisco IOS Software, Catalyst 4000 L3 Switch Software (cat4000-I9K91S-M), Version 12.2(25)EWA9, RELEASE SOFTWARE (fc3)

*

earthswitch uptime is 32 minutes

System returned to ROM by power-on

System restarted at 07:33:59 cdt Thu Sep 11 2008

System image file is "bootflash:cat4500-ipbasek9-mz.122-31.SGA.bin"

note: Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500-IPBASEK9-M), Version 12.2(31)SGA, RELEASE SOFTWARE (fc3)

*

1 ACCEPTED SOLUTION

Accepted Solutions

Re: by power-on .VS. by power cycle (SP by power-on)

Hello my ex-coworker friend.

I believe you are mentioning the difference between an actual power-on (power down physically) or by doing a power cycle via CLI commands:

power cycle module 1

or

hw-module power-supply 1 power-cycle

Let me know if this helps.

*btw SP is for supervisor

Vlad

2 REPLIES
Hall of Fame Super Silver

Re: by power-on .VS. by power cycle (SP by power-on)

Hello Daniell,

how many supervisors are in the first chassis ?

If they are two the SP could refer to the standby processor

Otherwise I would think it is just a different way to say the same.

Hope to help

Giuseppe

Re: by power-on .VS. by power cycle (SP by power-on)

Hello my ex-coworker friend.

I believe you are mentioning the difference between an actual power-on (power down physically) or by doing a power cycle via CLI commands:

power cycle module 1

or

hw-module power-supply 1 power-cycle

Let me know if this helps.

*btw SP is for supervisor

Vlad

3338
Views
0
Helpful
2
Replies