Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

c 3750X will not complete image load

Hi

I have an issue with a c3750x that was previously working with a good config on it which included the "no ip setup express" command.

Basically now when I boot the switch it gets this far and stops...

  

Using driver version 1 for media type 2

Base ethernet MAC Address: 44:d3:ca:09:5d:80

Xmodem file system is available.

The password-recovery mechanism is enabled.

Initializing Flash...

mifs[2]: 12 files, 1 directories

mifs[2]: Total bytes     :    2097152

mifs[2]: Bytes used      :     755200

mifs[2]: Bytes available :    1341952

mifs[2]: mifs fsck took 2 seconds.

mifs[3]: 0 files, 1 directories

mifs[3]: Total bytes     :    4194304

mifs[3]: Bytes used      :       1024

mifs[3]: Bytes available :    4193280

mifs[3]: mifs fsck took 3 seconds.

mifs[4]: 5 files, 1 directories

mifs[4]: Total bytes     :     524288

mifs[4]: Bytes used      :       9216

mifs[4]: Bytes available :     515072

mifs[4]: mifs fsck took 1 seconds.

mifs[5]: 5 files, 1 directories

mifs[5]: Total bytes     :     524288

mifs[5]: Bytes used      :       9216

mifs[5]: Bytes available :     515072

mifs[5]: mifs fsck took 1 seconds.

mifs[6]: 7 files, 1 directories

mifs[6]: Total bytes     :   57671680

mifs[6]: Bytes used      :     177664

mifs[6]: Bytes available :   57494016

mifs[6]: mifs fsck took 44 seconds.

...done Initializing Flash.

done.

Loading "flash:c3750e-universalk9-mz.122-58.SE2.bin"...@@@

    

I am unable to halt the boot process (with the break sequence ) and get in to ROMMON mode and the MODE button on the front of the switch isnt allowing me to break the boot sequence either.

If anyone out there can offer any suggestions I'd be very grateful.  Thanks.

Paul

Everyone's tags (3)
1 REPLY
Hall of Fame Super Gold

c 3750X will not complete image load

MODE button on the front of the switch isnt allowing me to break the boot sequence either.

Try this ... Stand the appliance on the Mode button and power it up.  Wait for 30 seconds and see whether or not the appliance goes into a full-blown factory reset. 

If not, then I recommend you contact Cisco and get the appliance RMA-ed.

And by the way, please avoid (at all cost) using IOS version 12.2(58)SE and later.  If you need a stable IOS version, try 12.2(55)SE8 or 15.0(2)SE4.  Don't even attempt to try anything else.

109
Views
0
Helpful
1
Replies
CreatePlease login to create content