Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

c1800isr and static nat

I have two exchange 2010 mail servers behind a c1800isr.  Mail server two has a static nat as below

ip nat inside source static <inside address> <outside address> route-map nonat_static.  We want mail server two to send mail out the outside address specified for it in the static nat statement.  It is not doing this however and is sending mail out the interface outside interface address.  Is the ip nat inside statement supposed to force the server to send out that address

  • LAN Switching and Routing
3 REPLIES
Cisco Employee

c1800isr and static nat

Clear the existing NAT translation table as it might have an existing translation before you configure the above static NAT statement.

Command:

clear ip nat translation *

The above command will clear all the existing translation.

New Member

c1800isr and static nat

This was a nat exemption statement that was needed.  Thanks for the reply though

Cisco Employee

c1800isr and static nat

Great to hear, and thanks for the update.

280
Views
0
Helpful
3
Replies
This widget could not be displayed.