Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

C1841 Router with HWIC-4ESW

This 1841 router has a WAN Interface

(WIC-1DSU-T1-V2), two embedded Fast Ethernet Interfaces, and a Four-port 10/100 Ethernet switch interface card.

My question is in regards to the 4-port switch. Is it in its own subnet, separate from the embedded ports?

To manage the switch would I have to connect via one of the 4 ports on the card, or could I connect via one of the embedded interfaces?

3 REPLIES

Re: C1841 Router with HWIC-4ESW

you can manage the switch either via the wan or the embedded ports.

If you configure a SVI, then you can manage it throught it as well.

above all console is always there :-)

Narayan

New Member

Re: C1841 Router with HWIC-4ESW

Should the devices connected to the 4ESW 4-port switch be configured for a subnet that is different than the embedded Ethernet ports?

How would I give an IP address to the 4ESW for management purposes?

Re: C1841 Router with HWIC-4ESW

Create an SVI and assign an ip address to that as you in any normal L3 switch

int vlan 1

ip address x.x.x.x y.y.y.y

no shut

HTH

Narayan

361
Views
0
Helpful
3
Replies