Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

edw
New Member

C2800 Series with Integrated Switch

Hi,

I have a C2821 with a Switchcard - I wantto get the vlans working. I am used to C6000 Series, however this model does not allow for set commands etc I have tried to get VTP flowing between them - the card is known as GI1/0.

!

!

interface GigabitEthernet0/0

no ip address

shutdown

duplex auto

speed auto

!

interface GigabitEthernet0/1

no ip address

shutdown

duplex auto

speed auto

!

interface GigabitEthernet1/0

no ip address

!

interface GigabitEthernet1/0.1

no ip address

!

interface GigabitEthernet1/0.1

encapsulation dot1Q 1 native

ip address 10.1.1.254 255.255.255.0

no snmp trap link-status

!

interface GigabitEthernet1/0.2

encapsulation dot1Q 2

ip address 10.2.1.254 255.255.255.0

no snmp trap link-status

!

ip classless

!

no ip http server

Show VTP Counters shows this:

VTP pruning statistics:

Trunk Join Transmitted Join Received Summary advts received from

non-pruning-capable device

---------------- ---------------- ---------------- ---------------------------

R-CORE-1#show vtp coun

VTP statistics:

Summary advertisements received : 0

Subset advertisements received : 0

Request advertisements received : 0

Summary advertisements transmitted : 0

Subset advertisements transmitted : 0

Request advertisements transmitted : 0

Number of config revision errors : 0

Number of config digest errors : 0

Number of V1 summary errors : 0

VTP pruning statistics:

Trunk Join Transmitted Join Received Summary advts received from

non-pruning-capable device

---------------- ---------------- ---------------- ---------------------------

R-CORE-1#

I have created a databse on the router but its not propergatting to the switchcard or a seperate switch ? What have I done wrong - I can't seem to use trunk commands on this but reading a cisco tech thing the above should work !?!?

I have added a switch plugging into the integrated switch and these are communicating fine:

VTP statistics:

Summary advertisements received : 3

Subset advertisements received : 1

Request advertisements received : 0

Summary advertisements transmitted : 3

Subset advertisements transmitted : 1

Request advertisements transmitted : 11

Number of config revision errors : 0

Number of config digest errors : 0

Number of V1 summary errors : 0

VTP pruning statistics:

Trunk Join Transmitted Join Received Summary advts received from

non-pruning-capable device

---------------- ---------------- ---------------- ---------------------------

Gi1/0/2 0 0 0

Fa1/0/16 0 0 0

Do you create the vlans on the integrated switch instead and ifso does this mean the router won be routing them ???

Thanks for any help

Ed

  • LAN Switching and Routing
2 REPLIES

Re: C2800 Series with Integrated Switch

Hi,

You need to create VLANS with this command:

#vlan database

it will take you in another mode ..

If you find this post usefull

please don't forget to rate this

#########################################

#Iwan Hoogendoorn

#########################################

edw
New Member

Re: C2800 Series with Integrated Switch

Hi,

I know that ;) I created a vlan database on the router but the problem is it isnt propergating to the integrated switch ??

Thanks

Ed

121
Views
0
Helpful
2
Replies
This widget could not be displayed.