I have a C2950 which is responding to ping requests very slow as well as managing the switch is extremely slow. The clients off the switch respond to ping requests quickly so it is looking like it is only the management side of the switch. CPU Utilization is minimal:
CPU utilization for five seconds: 1%/0%; one minute: 2%; five minutes: 2%
Also ping requests from a switch directly connected to it are just as slow.
Any suggestions what to look at next? I cannot reload the switch at the moment as there are working clients off it.
On the trunk interface between the C2950(7 Vlans) and the trunk on the C2950 (2 Vlans) I have added switchport trunk allowed vlans 1,200,1002-1005. This seems to have cured the problem. The 2 Vlans on the C2950 having trouble are Vlan 1 and Vlan 200. So I have corrected this particular issue but I am not sure what the cause was. Something to do with SPT I would say now.
Yes you are right, there was a bug also listed for the same and that was the reason I asked you how many vlans you have on your active core switch and on 2950 switches.
It is recommended that if you do not have any active vlans on your 2950 switch and your core switch is capable of handling large number of vlans you should either prune them from trunk or clear them up from trunk.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.