Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Bronze

C2960 password-recovery status show command

Ok, so I enabled the "no service password-recovery" command on my C2960 switch.

All seems to work as discribed.

Only issue I have is --- which show command is used to reveal if the password-recovery feature is enabled of disabled as the command doesn't show up in the running config after you enable it ?

:

NOTE:

The command does show up in the C2960 switch in config t mode (unlike the IOS router 2800 series), but doesn't show up in the running-config after you enable or disable it.

On the 2800 series routers (latest IOS) in config t mode the command does not show up but if you type "no service passowrd-recovery" the command function correctly and it does list it in the running configuration. Strange!

:

Tks

Frank

1 REPLY
Hall of Fame Super Gold

C2960 password-recovery status show command

sh version

sh run

881
Views
0
Helpful
1
Replies
CreatePlease to create content