Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

C3020 speed nonegociate issue ??

Hi

from configuration guide we can set

speed no negociate on C3020's SFP port

but i do no find this command see above

any comments welcomed

JYP

Cisco IOS Software, CBS30X0 Software (CBS30X0-IPBASE-M), Version 12.2(50)SE, RELEASE SOFTWARE (fc1)

Copyright (c) 1986-2009 by Cisco Systems, Inc.

Compiled Sat 28-Feb-09 00:18 by weiliu

Image text-base: 0x00003000, data-base: 0x01540000

GigabitEthernet0/20 is up, line protocol is up (connected)

Hardware is Gigabit Ethernet, address is 001f.9d7c.f914 (bia 001f.9d7c.f914)

MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation ARPA, loopback not set

Keepalive not set

Full-duplex, 1000Mb/s, link type is auto, media type is 1000BaseSX SFP

Switch#conf t

Enter configuration commands, one per line. End with CNTL/Z.

Switch(config)#inter

Switch(config)#interface gi

Switch(config)#interface gigabitEthernet 0/20

Switch(config-if)#s?

service-policy shutdown small-frame snmp

source spanning-tree srr-queue storm-control

switchport

Switch(config-if)#s

1 REPLY
Bronze

Re: C3020 speed nonegociate issue ??

The 1000BASE-SX SFP module ports support the nonegotiate keyword in the speed interface configuration command. Duplex options are not supported.

If you are connected to a device that does not support autonegotiation, you can configure speed on copper SFP module ports; however, you can only configure fiber SFP module ports to not negotiate (nonegotiate).

When configuring an interface speed and duplex mode, note these guidelines.

http://www.cisco.com/en/US/docs/switches/blades/3020/software/release/12.2_25_sef1/configuration/guide/swint.html#wp1080632

258
Views
0
Helpful
1
Replies
CreatePlease login to create content