Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

C3560-G switch RPS power checking

Hi

I have a switch that is plugged to two power sources:

1- The normal AC power

2- Redundant DC power supply (RPS)

I was checking in the " show environment" output the status of the 2  power sources, and got the below output,

My concern is about the DC Power, is it Normal like this?

Best regards,

Core-SW#sh env all

FAN is OK

TEMPERATURE is OK

Temperature Value: 39 Degree Celsius

Temperature State: GREEN

Yellow Threshold : 55 Degree Celsius

Red Threshold    : 65 Degree Celsius

SW  PID                 Serial#     Status           Sys Pwr  PoE Pwr  Watts

--  ------------------  ----------  ---------------  -------  -------  -----

1  Built-in                                         Good

SW  Status          RPS Name          RPS Serial#  RPS Port#

--  -------------   ----------------  -----------  ---------

1   Active          <>

Core-SW#

Core-SW#

1 REPLY

Re: C3560-G switch RPS power checking

Yes this is normal. You can only get control features and advanced info with the 3750 series and above with stackables.

823
Views
0
Helpful
1
Replies