Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

C3750 traffic policing

Dear All,

I have C3750 - Enhanced image switch, on port G1/0/1 FTP server is connected with the IP 192.168.1.10, i want to police the incoming FTP traffic from 192.168.1.10 and going to VLAN 192.168.2.0/24, i configured the following QoS but it didn’t work:

access-list 110 permit tcp 192.168.1.0 0.0.0.255 eq ftp 192.168.2.0 0.0.0.255

access-list 110 permit tcp 192.168.1.0 0.0.0.255 eq ftp-data 192.168.2.0 0.0.0.255

class FTP

match access-group 110

policy map POLICE                                                                  

class FTP

  police 10000000 8000

int g1/0/1

service-policy input POLICE

I think the access list is not right, because the FTP is passive FTP, is there any method to match the ftp traffic on the c3750?

Thanks and regards

2 REPLIES

Re: C3750 traffic policing

Hi,

Check out the below link it is having good documentation on applying Qos

http://www.cisco.com/en/US/products/hw/switches/ps5023/products_tech_note09186a0080883f9e.shtml

Hope this helps your query !!

Regards

Ganesh.H

Silver

Re: C3750 traffic policing

Hi

I sugest You try to add these lines to the access-list

access-list 110 permit tcp 192.168.1.0 0.0.0.255 192.168.2.0 0.0.0.255 eq ftp

access-list 110 permit tcp 192.168.1.0 0.0.0.255 192.168.2.0 0.0.0.255 eq ftp-data

/Mikael

610
Views
0
Helpful
2
Replies
CreatePlease to create content