C4K_PKTPROCESSING-4-UNKNOWNBRIDGEORROUTE:

[rhl_china]

In Switch4506 pop-up the log information.

There isn't specific configuration in the device.

The mac-address is a specific server's net card's address. The server maybe will send the packets which likes the ARP spoofing packets.

I want to screen this log information. How can I do? Thanks.

bridge replicated software-processed packet with source address 00:90:0B:06:69:1F and destination address 00:00:0C:07:AC:69

*May 28 16:58:37: %C4K_PKTPROCESSING-4-UNKNOWNBRIDGEORROUTE: (Suppressed 1 times)Unable to determine whether to route or bridge replicated software-processed packet with source address 00:90:0B:06:69:1F and destination address 00:00:0C:07:AC:69

*May 28 17:22:21: %C4K_PKTPROCESSING-4-UNKNOWNBRIDGEORROUTE: Unable to determine whether to route or bridge replicated software-processed packet with source address 00:90:0B:06:69:1F and destination address 00:00:0C:07:AC:69

[smahbub]

Error Message C4K_PKTPROCESSING-4-UNKNOWNBRIDGEORROUTEREPLICATED: Unable to determine whether to route or bridge replicated software-processed packet with source mac [mac-addr] , destination mac [mac-addr] , source IP [ip-addr] , destination IP [ip-addr]

Explanation :When a replicated packet is sent to the software by an output ACL, the hardware does not indicate whether the packet needs to be bridged or routed. When resources are exhausted or when the ACLs that are programmed in the hardware cannot handle processing directly (such as ACLs matching TCP flags), the supervisor engine sends the packets to the software for processing. If the software cannot determine whether to bridge or route, the packet might be dropped. This drop indicates that the packet was directed to a Hot Standby Routing Protocol (HSRP) router group MAC address.

Recommended Action :This is an informational message only. No action is required.