I know it's old stuff, but I have a C5500 with a Route Switch Module, IOS 12.0(7)T. This has been stable for 10 years. This morning, the RSM started to reload every 10 minutes with the following log entries:
Nov 4 09:33:07: %VIP2-1-MSG: slot9 System reloaded by a Bus Error exception
Nov 4 09:33:07: %VIP2-1-MSG: slot9 caller=0x600DCEE0
Nov 4 09:33:07: %VIP2-1-MSG: slot9 System exception: sig=10, code=0x8, context=0x604A5BC0
Nov 4 09:33:07: %VIP2-1-MSG: slot9 $0 : 00000000, AT : 00000008, v0 : 00000000, v1 : 0000005
It looks like the problem is being caused by the VIP2 adapter on the RSM, which is connected to Slot 9 on the Route Switch Module.
Slot 0: C5IP controler
Slot 7: Route/Switch Processor
Slot 9: VIP2 controler
The VIP2 has an ATM Port Adapter which I am no longer using. We reseated the RSM, and it has run clean for a day, but I am going to completely remove the VIP2 before it starts acting up again, which I hope will fix the problem.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...