Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

C6500 IOS config. Rx queue threshold

Hi,

Is this possible?

I can on CatOS but the magic CatOS>IOS converter web page does not help.

The current threshold setting is,

sh queueing interface GigabitEthernet 9/1 | b Queueing Mode In Rx direction

?

Queueing Mode In Rx direction: mode-cos

Receive queues [type = 1q2t]:

Queue Id Scheduling Num of thresholds

-----------------------------------------

1 Standard 2

queue tail-drop-thresholds

--------------------------

1 100[1] 100[2]

queue thresh cos-map

---------------------------------------

1 1 0 1 2 3 4 5 6 7

1 2

but i'd like to change it to,

queue thresh cos-map

---------------------------------------

1 1 0 1 2 3 4 6 7

1 2 5

Regards, MH

1 REPLY
New Member

Re: C6500 IOS config. Rx queue threshold

Try the command wrr-queue cos-map on your switch.This would reset the cos-map command.Refer URL

http://cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a008015bf98.shtml#use_output

106
Views
0
Helpful
1
Replies
CreatePlease to create content