Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

C6506-SXH1

Platform : C6506, 2xSUP720-3B, 122-33.SXH1

Linecards : SW-X6516(2),6516A(2).SSO on.

Command : show fabric

Resp : switching Mode = CROSSBAR for Mod 1,2,3,4,6- dCEF for mod 5 - Where can I find some explanations about CROSSBAR in 122SX ? I know crossbar for.. computers .

Furthermore I don t have dCEF hw-card ??

Best Regards

FF

2 REPLIES
Hall of Fame Super Bronze

Re: C6506-SXH1

New Member

Re: C6506-SXH1

Hi,thanks very much for the doc, my pb follows :

Ive 2 C6506(1edge-1campus)each has 2Sup720-3B

2 Eth-Gb-links (one Ipv4,one Ipv6),then end of Whitney1.O,122-33SXH+SSO running,OK.Then SXH1 installed on both.Now when I run SXH1 I get ONLY incoming streams(outside) AND no outcom.

from edge therefore no Internet access.In spite of the fact that eBGP peerings (between edge and NR)and iBGP between the 2 C6k are OK.

On edge Sup720 are HW 5.4,Fw 8.4(2).

On campus Slot5:Hw 5.3,Fw 8.5(1), Slot6 like above.Do you have any idea ? Thanks in advance

Regards

Francois

109
Views
0
Helpful
2
Replies