Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

C6509 boot from PCMCIA

Hi all, I have a Cat6500 x6k-sup2-2ge running an IOS software.

My problem is that I'm stuck in rommon mode after the IOS upgrade. Now I have A PCMCIA and I want to boot a new IOS from the PCMCIA.

I cannot format the PCMCIA from the rommon mode.

How can I format the PCMCIA? The only way is format from a target Catatalyst switch?

All these because I have an error about invalid magic number when I insert the PCMCIA card into the Supervisor2 slot in rommon mode.

Please I need your help,

Thanks in advance.

David

2 REPLIES
Cisco Employee

Re: C6509 boot from PCMCIA

Hi David,

Take the PCMCIA card to another sup2 and format it. Then copy the image from that device or from a FTP Server to the PCMCIA card.

Is there an image on the supervisors 'sup-bootflash: ?

To check see below CLI:

rommon 1 > dev

Devices in device table:

id name

bootflash: boot flash

disk0: PCMCIA Disk 0

Then list the contents of bootflash:

rommon 2 > dir bootflash:

Then:

rommon 3 > boot bootflash:image name

After the image is successfully loaded you can format PCMCIA card and copy the image you need.

For this problem your options are pretty limited.

Hope this helps.

-Hamam

Bronze

Re: C6509 boot from PCMCIA

Thanks a lot Haman, I gonna do that, just this question please:

- is there any problem if I format the PCMCIA from a sup720 or sup (not sup2)?

Thanks a lot again.

David

158
Views
0
Helpful
2
Replies