I am facing exact same problem. I set the read only and read/write SNMP community string for Call Manager in Cisco Serviceability SNMP settings, but LMS could still not communicate with Call Manager via SNMP. I have edited the credentials in LMS for the call manager but still could not get LMS to communicate with Call Manager.
LMS credential verification for Call Manager shows 'wrong credentials' for SNMP community.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...