I am working on a design that will see VSS implemented in the distribution and core of a campus network design. My plan is to use a layer 3 port-channel between my two VSS (dist/core) and run a IGP between the two. Vlans for each area of the campus will be terminated on the distribution switches for each area of the campus. I do have one slight issue however in that I need to span a couple of vlans campus wide, so the gateway for these vlans will terminate on the core. I was just wondering how people went about doing this and what technologies/best practices there are to satisfy this requirement.
Anyone have an opinion on this? In my campus I plan to deploy L3 between the distribution blocks and cores. Only issue is that I have a site wide WiFi network that I need to implement that will span the whole campus. The only way I can see myself doing this is spanning the vlan across the campus. The issue is I will have L3 not l2 links between the distribution blocks and the core. Any ideas or suggestions as to how I can best achieve this?
Thanks Robert, I probably should have elaborated on the infrastructure I plan to use. We will have a pair for 4500E's in the core (not really a core as we typically know it) and 4500X's in the distribution block. I seem to recall reading that the 4500X's don't suppose L2TP.
I have the physical capacity to cater for a L2 port from the distribution block to the core, but just wondered if this was the best way of doing this?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.