Re: Can DMZ be set up on same switch? Only have one 2960-S switc
I need to set up a DMZ but do not have a second switch. Is this possible on the 2960-S switch configuring specific ports?
It's not clear without your topology but as a general answer yes you can create vlan on your 2960 switch and have the L3 interface for that vlan routed off the firewall. You must make sure that there is no L3 interface on a L3 switch for that vlan though.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...