Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Can I check utilization on 4510E backplane

I am looking at moving from Sup 6E to 7 mainly for 10G support and NetFlow.  Backplane doubles from 32 to 64 it looks like.  Is there a way I can se if the existing 32G backplane is under stress to see if a backplane upgrade is needed regardless now?

Everyone's tags (2)
3 REPLIES

Re: Can I check utilization on 4510E backplane

Hi,

Can you check if below is supported on your box..I am not sure for 4500

#sh fabric ?
  active            crossbar fabric linecard active and backup info
  channel-counters  fabric channel counters
  clear-block       clear-block congestion control for fabric channels
  drop              drop counters for different queues in fabric
  errors            fabric port errors
  status            status of crossbar fabric
  switching-mode    crossbar fabric and system switching modes
  utilization       fabric port utilization percentage

Regards

Mahesh

New Member

Re: Can I check utilization on 4510E backplane

I have a WS-C4510R-E with 12.2.44.SG

the sh fabric command not available.

Hall of Fame Super Silver

Re: Can I check utilization on 4510E backplane

Hello Robin,

try to use

show platform health

Hope to help

Giuseppe

786
Views
0
Helpful
3
Replies