I want to run a TCL script inside EEM applet. The process will b: I capture the log like "neighbor down" and run some configuration command. Immediately after that, the TCL script starts running. TCL script is monitor the link by simply ping a IP for several times and regexp the successful rate. After that TCL script running finish, I want to run some configuration command again. Then this applet is finished. Is it possible to run a predefined TCL script from the FLASH inside the EEM applet? Is there any good guide? Thanks!
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...