Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Can I Span The Same Port Twice ?????

I would just like to check can I span the same port twice?????

At the moment I have a request from a customer who has port spanned on the outside of the firewall on a 6509, that is working, but their device isn't able to cope. They have asked if I can span the port again, so they can monitor the traffic again on a new device they are going to install?

I have mentioned to them about vlan filters, but they want to span the ports twice.

I just need confirmation that this can or cannot be done

Thank you in advance.

4 REPLIES

Re: Can I Span The Same Port Twice ?????

Hi,

Is possible with RSPAN only.

Only one destination port is allowed per SPAN session, and the same port cannot be a destination port for multiple SPAN sessions.

Each RSPAN destination session has one or more destination interfaces for each RSPAN VLAN that they support.

?RSPAN destination sessions are limited to two, or one if a local SPAN or a source RSPAN session is configured on the same switch.

Hope that helps

Regards,

~JG

New Member

Re: Can I Span The Same Port Twice ?????

Easy fix. Insert a TAP between the switch-span and the monitoring device.

switchspan--------olddevice

using TAP

switchspan --------TAP -------olddevice

The TAP gives you a 3rd interface that you can plug into the new device. This way you don't have to mess with anything on the switch.

hth,

Ted

Re: Can I Span The Same Port Twice ?????

Yes, the easiest way out would be to have a hub connected to the spam destination port.

I have also seen some implementations with Radware switches connected to the span destination that can intelligently load balance the traffic to multiple servers

HTH

Narayan

New Member

Re: Can I Span The Same Port Twice ?????

I have tried this on the 6509, and it can be down? Why the customer wants don't know. But, it allows you to span the same vlan to different ports.

This can be signed off! ☺

319
Views
0
Helpful
4
Replies