Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

can I use Cisco gbic in Juniper netwscreen slots?

hi;

can I use Cisco gbic in Juniper netwscreen slots?

2 REPLIES

Re: can I use Cisco gbic in Juniper netwscreen slots?

Hi

Do you think that it will fit onto Netscreen?

Regards

JD

Green

Re: can I use Cisco gbic in Juniper netwscreen slots?

It will probably work, but is not a supported config. You may be killing your warranty / service agreement.

Also, it has to be be the same type of GBIC. Chances are it needs to be an SX GBIC. If your Cisco GBIC is an LX or ZX, this is NOT something you'll want to do (unless the other side is also an LX or ZX -or other type-)

You also want to make sure the GBIC is for the same fiber type (single / multi-mode).

Good Luck

Scott

193
Views
0
Helpful
2
Replies