Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Can not ping anywhere from Cat65

Why I can not ping anywhere from Cat65.

No access-list filter icmp on Cat65.

14 REPLIES

Re: Can not ping anywhere from Cat65

Check your SVI interfaces are up check your static/dynamic routes

Community Member

Re: Can not ping anywhere from Cat65

It is fail to ping even the clients on all directed connected interfaces.

Re: Can not ping anywhere from Cat65

post your config for review - remove sentitive information.

Community Member

Re: Can not ping anywhere from Cat65

Here is.

Re: Can not ping anywhere from Cat65

check

!

vlan access-map icmp 10

match ip address 194

action drop

vlan access-map icmp 20

match ip address 192

action forward

!

So see if the source/destination of the pings is allowed.

Community Member

Re: Can not ping anywhere from Cat65

I was remove acces-list 194.Did not fixed.

Acess-list 192= permit ip any any

Do you think it will fix?

Re: Can not ping anywhere from Cat65

What is the source IP address you are using for the ping? what are the desitinations? Is it all VLAN's or just some?

Community Member

Re: Can not ping anywhere from Cat65

From Cat65( not specify) or any VLAN's IP addresses to any hosts on(within) Cat65 VLANs.

Re: Can not ping anywhere from Cat65

Sorry this makes no sense.

let me ask you this - from a host on a any of the vlans can you ping the Cat?

When you ping a host from the cat using a source IP of the cat does this also fail?

Community Member

Re: Can not ping anywhere from Cat65

I can not ping from hosts on any VLANs to Cat.

ping a host from the cat using a source IP of the cat does fail too.

Only hosts to any hosts(any VLANs) works fine.

Re: Can not ping anywhere from Cat65

check

!

vlan access-map icmp 10

match ip address 194

action drop

vlan access-map icmp 20

match ip address 192

action forward

!

So see if the source/destination of the pings is allowed.

Community Member

Re: Can not ping anywhere from Cat65

I will try tomorrow due to I can not access to my customer cat now.

Community Member

Re: Can not ping anywhere from Cat65

I take out this two vlan access-map.But problems is same- can not ping from cat.

I revise my previous email -

I can ping from hosts to cat.

Community Member

Re: Can not ping anywhere from Cat65

Andrew,

I fix it this morning.I take out "mls qos". Thanks for your help anyway.

224
Views
0
Helpful
14
Replies
CreatePlease to create content