07-23-2013 07:20 PM - edited 03-07-2019 02:33 PM
Dear all!
yesterday I tried to plug the WS-X4606-X2-E module to WS-C4506-E
but when I show module, the switch can not recognize new module
SW4506_1#show module
Chassis Type : WS-C4506-E
Power consumed by backplane : 0 Watts
Mod Ports Card Type Model Serial No.
---+-----+--------------------------------------+------------------+-----------
1
2
3
6 0 Unsupported module WS-X4606-X2-E
My IOS is:
bootflash:cat4500-entservicesk9-mz.122-44.SG.bin
I read in this link:
and my switch is full support this module...
what must I do now?
Solved! Go to Solution.
07-23-2013 08:49 PM
HI ,
You have Sup 5 were in this module is not supported.
This module is supported from Sup6-E, Supervisor Engine 6L-E, and the Supervisor Engine 7-E.
HTH
Regards
Inayath
***
Please rate useful posts and remember to mark any solved questions as answered. Thank you.
07-23-2013 08:10 PM
Phi,
Could you please check the requirement(Sup) and if this all there let me know:
HTH
REgards
Inayath
07-23-2013 08:37 PM
this is my current Sup:
Mod Ports Card Type Model Serial No.
---+-----+--------------------------------------+------------------+-----------
1 2 Supervisor V 1000BaseX (GBIC) WS-X4516
Is it not support for WS-X4606-X2-E :| ???
07-23-2013 08:49 PM
HI ,
You have Sup 5 were in this module is not supported.
This module is supported from Sup6-E, Supervisor Engine 6L-E, and the Supervisor Engine 7-E.
HTH
Regards
Inayath
***
Please rate useful posts and remember to mark any solved questions as answered. Thank you.
07-23-2013 09:17 PM
Thanks for your support!
rgds!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: