Can someone advise me if the 6.3 Watts listed for the 7960G is the start up figure or the stable use requirement. Also, can anyone tell me how many watts are required by a power cube require to deliver this level to the phone on a steady state basis.
Re: Can someone advise me if the 6.3 Watts listed for the 7960G
Initial startup power via a PoE switch is 15.4W, however after the phone has booted and CDP kicks in it drops to 6.3W as this is what it 'requests' via CDP. You can test this easily by looking at the output of the command 'show power inline' after disconnecting and reconnecting the 7960 (or disabling the port or PoE via the CLI). Repeat the command several times to see the PoE changes.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...