I have two locations; office and Colo. They are connected by 2 Gig dark fiber pipes. I have VLAN 36 in the Office and VLAN 20 in the Colo. When i use Microsoft "My Network Places" in the Office, I can see all computers on both VLANs. When I use it in the Colo, I only see the Colo computers. I'm using standard inter VLAN routing with RIP 2.
Does anyone have any idea why this would work in only one direction?
On your VLAN 20 routed interface, do you have an ip helper-address command to forward the browsing broadcasts to the Domain Controllers and /or WINS servers? (I am unclear which you need to forward to, the DC or the WINS, but usually they are the same machines.)
Also, the Network Neighborhood will only work if you have NBT enabled on the client, but since it is working locally I suppose you do.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...