I hope that someone can help me, I'm trying to configure a L3 port in a VDC (NX_CORE_A) in my Nexus 7004 but I'm receiving the next output and I can't configure it:
NX_CORE_A(config)# int eth3/1 NX_CORE_A(config-if)# no switchport ERROR: Ethernet3/1: requested config change not allowed
I have no idea why I'm receiving this output.
This is my version:
ITA_MAIN_A# show version Cisco Nexus Operating System (NX-OS) Software TAC support: http://www.cisco.com/tac Documents: http://www.cisco.com/en/US/products/ps9372/tsd_products_support_serie s_home.html Copyright (c) 2002-2013, Cisco Systems, Inc. All rights reserved. The copyrights to certain works contained in this software are owned by other third parties and used and distributed under license. Certain components of this software are licensed under the GNU General Public License (GPL) version 2.0 or the GNU Lesser General Public License (LGPL) Version 2.1. A copy of each such license is available at http://www.opensource.org/licenses/gpl-2.0.php and http://www.opensource.org/licenses/lgpl-2.1.php
Software BIOS: version 2.12.0 kickstart: version 6.2(2) system: version 6.2(2) BIOS compile time: 05/29/2013 kickstart image file is: bootflash:///n7000-s2-kickstart.6.2.2.bin kickstart compile time: 7/9/2013 20:00:00 [08/22/2013 04:51:27] system image file is: bootflash:///n7000-s2-dk220.127.116.11.bin system compile time: 7/9/2013 20:00:00 [08/22/2013 08:07:03]
Hardware cisco Nexus7000 C7004 (4 Slot) Chassis ("Supervisor Module-2") Intel(R) Xeon(R) CPU with 12224956 kB of memory. Processor Board ID XXXXXXXX
Try using a SVI and assign the port into the vlan . Some of the nexus modules cannot do direct routing and have to use a different card to proxy the routing. I suspect the card you are trying this on is a L2 card only .Go here and look at the proxy routing section. To check to see if the card you are using is L2 only do a "show hardware proxy layer-3 detail" .
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.