Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Can't connect to FWSM on 6506

I established an ssh session to my 6506 and have priv 15 on my user account.

When I try to "session slot 5 proc 1" I get:

The default escape character is Ctrl-^, then x.

You can also type 'exit' at the remote prompt to end the session

% telnet connections not permitted from this terminal

Is there any way I can get to the FWSM via a ssh session to the 6506?

1 REPLY
Silver

Re: Can't connect to FWSM on 6506

This happens because the VTY (Telnet) is misconfigured as transport output none. try the following commands.

line vty 0 4

exec-timeout 60 0

transport input ssh

transport output telnet ssh

flowcontrol software out

line vty 5 15

exec-timeout 60 0

transport input ssh

transport output telnet ssh

flowcontrol software out

346
Views
0
Helpful
1
Replies
CreatePlease to create content