Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Can't Enable Port on 2940..why?

Cisco Catalyst 2940-8TF, there are two fiber option 1. mtrj interface 2.sfp interface.

I have nothing plugged into the sfp gig port. The mtrj port always says disabled, but I can't seem to enable it. Why?

5 REPLIES
New Member

Re: Can't Enable Port on 2940..why?

Have you told the switch that it is to use RJ45 and not the SFP slot for the interface?

I'm not familiar with the model in question but usually when you have multiple media types for one interface use need to set the media type, in this case:

int gig 0/1

      media-type rj45

Purple

Re: Can't Enable Port on 2940..why?

I agree it's usually a media type command , you have to choose one or the other , both cannot be live.

Silver

Re: Can't Enable Port on 2940..why?

Hi

Have You tried to reload the switch.

What I can remember, if there is an sfp installed when switch boots up, it will use sfp port and disable mtrj.

The mtrj will be disabled even if You remove the sfp. If this is Your case, You have to reboot the switch

/Mikael

New Member

Re: Can't Enable Port on 2940..why?

I had the opposite problem.  I used the MTRJ port and then tried to use the SFP which showed disabled.  Rebooting the switch worked.  Thanks for the tip.  Strange that you can't use the media-type command!

Hall of Fame Super Gold

Re: Can't Enable Port on 2940..why?

Hi David,

I've got this model and I don't recall seeing a "media type" command for the SFP/MTRJ port.

During the bootup, can you check if the POST is successful or fail?

Also try the command "sh post".

If worst-comes-to-worst, just RMA the darn thing.

602
Views
5
Helpful
5
Replies