Re: Can't get DHCP address with "ip verify unicast reverse-path"
The source address of 0.0.0.0 would be if some device were sending DHCP requests to your interface. But your situation is that you are sending requests to the ISP and they are sending responses. It looks like since the interface does not recognize the source address of the response (which would be the valid next hop address of the ISP device) that RPF is denying the packet. One of the options in RPF is to configure an access list which can specify traffic to accept. Perhaps you should modify your RPF configuration to have an access list and in the access list permit DHCP/bootp responses.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.