Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Can't get DHCP on 2611

Hello all,

I want to setup e0/0 on my 2611 to recieve DHCP address from my ISP (Comcast). I tried several variations of "ip address dhcp" on int e0/0 and nothing worked. The port is up, but NOT plugged in. Does that matter, because if it doesn't, I can't seem to setup DHCP and that's a major concern. Bottom line is that the IOS won't take the command...

On a side note, here's the IOS info:

Hercules#show ver

Cisco Internetwork Operating System Software

IOS (tm) C2600 Software (C2600-I-M), Version 12.1(27b), RELEASE SOFTWARE (fc1)

Copyright (c) 1986-2005 by cisco Systems, Inc.

Compiled Tue 16-Aug-05 17:55 by pwade

Image text-base: 0x80008088, data-base: 0x80833630

ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)

And yes, I'm somewhat of a Cisco newbie!

Thanks!

Chris

1 REPLY

Re: Can't get DHCP on 2611

Hi

You are currently running 12.1(27b) which is quite old and may not have all the feature u require.

If you have CCO id you better can run download the newer version so that you can have the required command configured..

You can refer this link for finding out the same..

http://tools.cisco.com/ITDIT/CFN/jsp/index.jsp

regds

210
Views
0
Helpful
1
Replies
CreatePlease login to create content