Can't ping the ip address that I assigned to a vlan
I have a Cisco 6506 that is one of my ciores switches in company. I ran into some UDLD issues when psanning tree detected a loop and disabled all the fiber interfaces in my datacnet. Nevethless, nos that I have disabled udld my management vlan 99 = 10.1.99.x/24 is having issues and I can't the ip address of 10.1.99.1/24 on my 6505 switch. My first step was recreating the vlan (no workie) then assign a different ip (no workie). Any ideas?
Re: Can't ping the ip address that I assigned to a vlan
Interestingly enough I have called Cisco support on this issue and found that while the vlan has been there (in the config startpu and current), the vlan was not in the vlan database. All that was required for me to do to get this to work was to:
switch# int vlan 9
that was it!!! amazing.It create the vlan in the vlan database - which I though had already existed. I hope this email helps some who can't figure out why a vlan that exists can be pinged.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...