Can't run cross module Etherchannel, same modules, different HW rev
Hi - I'm trying to create an Etherchannel bundle who's interfaces are spread accross some WS-X4548-GB-RJ45 modules.
This works fine if the HW revision of the modules is roughly the same - it works between cards which are Rev 2.4, but if I then add some ports to the channel on a WS-X4548-GB-RJ45 with HW rev 1.0, the ports stay in suspended mode. If we swap the module for one with a higher HW revision it works
I suspect this is an incompatability of some sort but can't find it documented anywhere
Has anyone else had this or a similar problem?
Or does anyone know where this might be documented on CCO?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...